You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Tuesday, March 18th 2014, 7:50pm

by SmartEarthAustin

Pressure can be checked with a static pressure gauge on a hose bib.

If it's attached to the a hose bib and reads above 25-30 psi with the zone on, I'm pretty certain it's the valve.

You can try that with other zones to compare the readings.

If all zones are designed with similar flow and pressure the readings should be real actively similar.

Tuesday, March 18th 2014, 7:46pm

by SmartEarthAustin

I would also check the valve itself.

I see lots of old irritrol valves that will come on but fully open. That causes a flow issue which can create a lack of pressure.

A valve opening only halfway from a stiff diaphragm really drops the pressure.

Hope it help.

Tuesday, March 18th 2014, 4:01am

by Groundhog (Guest)

Ok cool, how can I test my pressure though? Is their a product around or another way to do it.

Friday, March 14th 2014, 10:20am

by Wet_Boots

If the water is still flowing with the heads shut off, then you have a break to find. Take pressure readings of your water supply when the zones are running. High pressure at the supply when the bad zone is on is an indication of a bad valve or pipe blockage. Low pressure at the supply would point towards a broken pipe.

Friday, March 14th 2014, 4:15am

by Groundhog (Guest)

1 station of 8 not popping up?

I have 1 station of 13 hunter Pros-4 bodies with MP 1000 rotator heads attached, that isnt popping up.
Ive replace whole sprinkler units, swapped heads, blanked one of the sprinklerS (so that there were only 12), cleaned the ring filters, increased the flow on the valves only for them to stay down. The station is run by a control box that also runs 7 other stations which all work fine, so I am hesitant to think its a pressure issue. Although down the water is still flowing alot so i dont think it is a blockage.
Any ideas would be greatly appreciated...