You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4183 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Saturday, May 17th 2003, 2:59pm

by Rays Sprinklers

This could be many factors, What happens when the controller opens the valve. i would have to know a little more information like

1. What kind of valve is it?
2. What kind of controller is it?

Please Reply

Thanks
Ray
Rays Above and Beyond Automatic Lawn Sprinklers

Monday, June 17th 2002, 5:11pm

by Kevin

VALVE FAILS TO OPEN ON FIRST TRY

I have a question that I hope you can help me with.

I have three valves, with one zone each. Two of the valves work fine, however, #1 valve has a problem. When ever I turn on valve #1, initially, the valve seems to not open fully; the sprinkler heads mearly bubble and flood with no spray at all. Then when the valve is turned off, then turned right back on again, the valve opens and the sprinkler heads spray wonderfully.

Trying to trouble shoot this valve, I have repeated this procedure many times. Valve #1 always delays on the initial opening, then once shut off, then opened again, it works fine. All three valves have the same source of water and pressure. I have cleared the line many times and have ensured that the supply line is working properly.

I have replaced the diaphram, seal, and all other parts replaceable and the valve adjustment is open full. I have switched on and off the automatic timer and manually operated the valve. I don't know what to do, except replace the entire valve.

Could there be an air leak that would cause this? How does the diaphram work inside with the water pressure and the bleed screw or silinoid? Would a air leak cause this? All screws are tight and seem sealed.

I hope my email is descriptive enough.

Thank you for your help. :)


Kevin Scott