You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3986 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 10 posts

Tuesday, May 20th 2003, 11:08am

by Rays Sprinklers

If it is an irritrol 2400T thats easy to fix. Go online to sprinklerwarehouse and buy on. When it comes unsrew the bonnet. (Grey Ring) and pull out all the insides and top including the black ring. Then bring that outside to the bad valve. Unscrew the bad valve and then put in the new valve, into the old body (before putting the new guts in flush the valve. Also shut off the water before doing this) Then scew the bonnet on nice and tight, re wire, and turn on the water. If that dosnt work check your timer and wiring. HOpe that helps. Where are you located?

Thanks
Ray
Rays Above and Beyond Automatic Lawn Sprinklers

Sunday, May 18th 2003, 5:18pm

by RVLI

rob-
Did you replace the soleniod or the valve itself?


Sunday, May 18th 2003, 1:57pm

by rob

It is an Irritrol 2400T.


Sunday, May 18th 2003, 12:01pm

by Rays Sprinklers

What kind of valve is it?

Thanks
Ray
Rays Above and Beyond Automatic Lawn Sprinklers

Tuesday, April 29th 2003, 12:31pm

by RVLI

I would just replace the valve. Go to either Sprinkler Warehouse's online store and order the replacement before it gets too dry.

Thanks again!


Tuesday, April 29th 2003, 11:33am

by rob

Ok now I switched valve 6 & 7 and when I turn the water supply on zone 6 runs continuously while zone 7 stays off. Looks more and more like a bad valve / solenoid from the original zone 7. Agree? Thanks.


Monday, April 28th 2003, 4:36pm

by rob

Irritrol Total Control 9 station. I disconnected the power and had the same behavior as before.


Monday, April 28th 2003, 3:53pm

by RVLI

What kind of controller do you have?


Monday, April 28th 2003, 11:40am

by rob

I unscrewed, cleaned and reassembled. The problem still persists. I also noted this situation (I assume this was like this before). It is the zone 7 valve that runs continuously in the "off" position. If I turn this valuve "on" then zone 6 begins to run continuously even though the zone 6 valve is "off".

All valves "off" - zone 7 runs continuously
Valves 1-6 "off", zone 7 "on" - zones 6 & 7 run continuously

Any idea why this happens?


Monday, April 28th 2003, 10:07am

by rob

Does the diaphragm just screw off by hand, or do you need any tools?