You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 503 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Sunday, July 7th 2013, 1:35pm

by Wet_Boots

The top of the cap and the top of the riser must be above grade, which is counter-intuitive, since it will look like a tripping hazard. It's the only way that the riser part operates free from the presence of dirt.

Every carton of rotor heads from the major manufacturers will have a diagram showing how the head should be set. And it's always a bit higher than you'd expect.

Sunday, July 7th 2013, 12:35pm

by pman

You mean dirt damaged the riser?

I'm sure part of the cap was above grade, but there are still slight scratches on the riser.

Sunday, July 7th 2013, 9:00am

by Wet_Boots

If the head is installed so the top is not above grade, these things can happen, and you are basically out of luck, since the mfr instructions were not followed.

Sunday, July 7th 2013, 2:48am

by pman

Hunter pgj squirting water from neck collar

Is this a warranty issue, or can it be fixed?

This rotor is less than a year old, and water squirts from the cap collar, where the arrow is pointing. The water spirals up the riser assembly.
pman has attached the following file:
  • pgj.jpg (17.86 kB - 0 time downloaded )