You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1827 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Monday, May 20th 2013, 12:16pm

by Wet_Boots

Indoor install locations are always specified with a floor drain, because there can be a failure mode that has the device spewing water with full force, and not just drips and squirts.

Monday, May 20th 2013, 8:49am

by ktm250rider

backflow installation location

planning an install in central NH with a reduced pressure backflow. I would like to install it in the basement next to my mecahnical systems. I currently have two condensate pumps, one for my boiler and one for my air handler. these are self contained pumps where any water from the systems are collected and pumped out the side wall of the house. I supposed i could mount a pail under the RPZ and run a drain line to one of the condensate pumps. Any experience with this? It would be nice to not have to install the unit outside.