You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 555 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Monday, May 20th 2013, 8:04am

by dorins

Understood, thank you mrfixit!
Even if I don't re-associate the original zones back to how they were they should still be operating individually, I think?

Monday, May 20th 2013, 7:27am

by Wet_Boots

Sometimes zones are combined when a system is running the zones at a very high pressure, and two at a time results in better performance.

Monday, May 20th 2013, 7:10am

by dorins

Thank you, fixit, I will try and see what happens.
Btw, I noticed for the front yard (where one zone isn't working anymore), there are 4 valves in the box, one for each zone, but at the controller two wires (not the common) were attached to the same zone control... is there a reason why I would want to open and shut two valves simultaneously rather than separately?

Sunday, May 19th 2013, 9:30pm

by mrfixit

Pull the wire out of the controller. Resplice it. See what happens.
You didn't short anything out.
I'd suggest that you make sure the wire's attached to the correct terminal but you tried two different controllers. Unless it's the same model I doubt that's it.
If you can't get it working there's either a problem with the valve or the wiring..
You could move the wires around at the valves from a valve you know works to the valve that doesn't work and see if it comes on...

Sunday, May 19th 2013, 8:36pm

by dorins

Replaced old controller, now one zone does not work

I replaced an old (antique) controller with a Orbit 6 w/remote. I marked each wire and installed them in the new unit.
All the zones operate (at least in manual mode using the remote) except one. I even reinstalled the old controller and the zone is still dead. Could I have shorted a circuit, valve etc when I removed the old wires? Any suggestions?>