You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Thursday, May 9th 2013, 12:11pm

by lkool

No, I'd try to get those elbows under the ground if possible so the only exposed pipe is the one going straight down next to the wall.
This totally makes sense and it is what I am going to try to do. I am not sure that there is much ground to work with. So i might not be able to get deep enough to do this. If that is the case would you recommend digging even deeper and running pipes down and then up to achieve the desired result? Or possible running the sideways?

Thursday, May 9th 2013, 5:13am

by mrfixit

No, I'd try to get those elbows under the ground if possible so the only exposed pipe is the one going straight down next to the wall.

Wednesday, May 8th 2013, 11:43pm

by lkool

I think I am following you. I've attached a very simple drawing, is this what you are proposing the final pipe would look like?
lkool has attached the following file:
  • pipes.png (8.24 kB - 3 times downloaded - Last download: May 9th 2013, 9:50am)

Wednesday, May 8th 2013, 10:50pm

by mrfixit

It looks like a crappy installation job to me. That thing gushing water is a compression coupling. You don't need it. Take it out.
I'm assuming the pipe whoopty doo's there because the foundation's in the way. Maybe the guy was just lazy.
I'd dig down through the gravel a bit. Then cut the pipe. Install a 90 degree fitting over to match up with the pipe going straight down. Then attach the two with another 90.
If you can't do it below ground because something's in the way then do it low to the ground. Maybe inside the gravel somewhere.

Wednesday, May 8th 2013, 9:55pm

by lkool

Chicken or Egg?

I am a new to the sprinkler system world. I am starting up my system for the first time. I was running one zone at a time and checking to see that things looked good. The first 4 zones were good, when I switched to the 5th zone, I came out of the garage and heard gushing water. Water was shooting out the PVB as well as a gasket in the PVC pipe under the PVB.

My question is, what caused this and what came first? Is it a bad PVB that caused the gasket to fail or is it a failing gasket that is causing the PVB to gush water? Attached is a photo of the PVC failure. It shooting out of the portion of the pipe that has some sort of 'screw on' cap, near the ground before the right angle.

Thanks!
lkool has attached the following file:
  • pvcwater.jpg (11.74 kB - 11 times downloaded - Last download: May 13th 2013, 9:18pm)