You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 545 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Thursday, May 2nd 2013, 11:54am

by Scott76

What type of heads are you using and what nozzles are in them? The flow rate of the nozzles is given from the manufacturer in a chart based on pressure to the heads. Generally speaking, the flow is limited by the smallest piece of pipe in the system to the valve. If you use 1" main and zone lines, but only have a 5/8th's" meter, you are limited by the meter. That will set your available flow to the house and system. In the area I'm in, a 5/8th's" meter with 70 psi will give me enough water to run 6 or 7 heads, depending on nozzle selection. To make sure you know your flow, use a head with a pressure regulator in it and it will give you a fixed pressure out the nozzle. This will allow you to make very exact calculations. Add your flows up and see where you are at.

Tuesday, April 30th 2013, 11:28pm

by electrifiedmale

depends on how many Gallons a minute you have available and what the precipitation rate of the sprinklers are and how much loss there is in the system.

70 psi will not be 70 psi at the sprinkler heads, you must calculate the pressure loss in the pipes. Loss depends how big and how long the pipes are, the valves you are using, backflow you are using, loss of the meter, etc....

http://www.irrigationtutorials.com/sprinkler00.htm

Tuesday, April 30th 2013, 4:06pm

by Dave in Vegas

how many sprinkler heads per zone?

Have 70psi pressure and have 7 heads on one line. Too much?