You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 461 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Wednesday, April 24th 2013, 9:32pm

by Wet_Boots

Too much flow, or at least too much initial flow. Double check for leaks, and if your zone valve has a flow control, throttle it down.

Wednesday, April 24th 2013, 8:11pm

by BRK

Well Pressure Drops to zero when I turn on 1 Zone

I recently changed my well pump out. It was a 1/2hp and I put the same type in. My sprinker system which has 6 zones run perfectly. When I changed the pump zones 1,3-6 all run perfect. When zone 2 turns on my pressure drops to zero and my pump shuts off so the zone never comes on. I can hold the pressure switch to on and the pressure will build back up slowly, when it gets to 20psi I can let it go and the zone runs perfectly. Can you give me any suggestions?