You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2044 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Tuesday, April 9th 2013, 10:26pm

by Wet_Boots

Down the center is no good. You use half-circle heads along the curb, on both edges of the strip.

Tuesday, April 9th 2013, 3:53pm

by Buster10 (Guest)

Yep, that is what I did.

Tuesday, April 9th 2013, 7:39am

by Wet_Boots

Are you saying you installed a line of full-circle heads down the middle of the strip?

Monday, April 8th 2013, 10:01pm

by Buster10 (Guest)

Suggestions for 10' x 150' strip of grass

Our neighborhood entrance has one lane entering and one exiting that gives us a ten foot wide by 130 long strip of grass surrounded by asphalt. We installed hunter sprays every 12 feet and used 6 foot spray heads to keep from watering the street. Obvious mistake we have dry areas between the heads. I also notice the sprays do not give very even coverage.

Any suggestions in a spray head to purchase to give more even coverage of entire strip of grass? It is ok if we spray onto asphalt. Would MP rotators work better. They are expensive but if best choice we will purchase. Thanks.