You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 679 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Friday, January 18th 2013, 9:49am

by Bryan the Homeowner (Guest)

Thanks Guys, thats exactly what I needed

Wednesday, January 16th 2013, 7:07pm

by valovic

As far are the reducing T's. I would not change what you have, but if you are putting in something new it can't hurt to go to 1" . But your flow is pretty low, so you can't go wrong either way.

Monday, January 14th 2013, 1:56pm

by Wet_Boots

Backflow preventers have very high flow ratings, so you can feed 12 gpm from a 3/4-inch device

Monday, January 14th 2013, 11:16am

by Bryan the Homeowner (Guest)

1" Backflow on a 3/4" Tee??

Hi There,
Our builder placed a 3/4" stub on our 1.25" copper mainline to the house. My per zone usage for a set of rainbird spray heads is just under 12 gpm for each of 2 seperate zones, the other 2 are both drip. The Total length of my Mainline run (to my valve box) is pretty small, maybe 60' straight to the backyard from the side of the house. The designers at Rainbird suggested a minimum of a 1" Backflow and I have a couple of question for ya'll
1) Do I need to replace the 1" x 1" x 3/4" reducing Tee with a [1" x 1" x 1" standard Tee], or can I connect to that 3/4 without too much worry?
2) there is currently a 3/4 backflow attached, courtesy of the builder for the front yard drip system (which they put in before the sale). Any chance I could simple stick with this or is rainbord right on track that I really need to move to a 1" backflow?
Thanks in advance!