You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 805 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 7 posts

Saturday, October 6th 2012, 8:53am

by sprinklerkrat

Update: A day later all zones/valves worked fine turns out I have some kind of short on my rain sensor. When bypassing it everything works. The zone I split into 2 different manual zones with ball valves (low flow drip zone and regular sprinkler zone) operates fine. Thanks for all the comments though! See you next time something breaks.

Tuesday, September 18th 2012, 2:38pm

by Wet_Boots

the 205 valves are always repairable, and you should have a spare valve on hand, in case you need to do a swap of all the parts plus the cover

Tuesday, September 18th 2012, 11:47am

by sprinklerkrat

Ok. So is it possible
I did permanent damage to my main valve?
I believe I have Hardie (or iritrol) 205 valves.
Is there any way to fix or reset the valve? How do I best troubleshoot it?


Thanks for chiming in.
I certainly appreciate all the great info on these forums.

Tuesday, September 18th 2012, 8:25am

by Wet_Boots

Very low flow is outside the capability of most zone valves. You can buy a special valve designed for low-flow drip, but they cost big bucks.

Tuesday, September 18th 2012, 4:07am

by sprinklerkrat

No, I haven't shut the water off at all. I just kept my system off while I installed the ball valves.

Tuesday, September 18th 2012, 1:14am

by mrfixit

Did you shut the water off at the backflow device?
Could be a problem with the master valve.

Monday, September 17th 2012, 11:10pm

by sprinklerkrat

System not starting after manual zone install

Need someone to point me in the right direction please.....
I had a perfectly fine, working Hardie 9 zone system. I just installed 2 manual ball valves off of my 9th zone (after the 9th zone valve). My intent is for one ball valve to feed my small vegetable garden drip system 7 days a week. When I want the zone to operate as normal with pop up sprinklers, I'll close the drip irrigation ball valve and open the ball valve that feeds the several pop-up sprinklers.
My problem...I tested my ball valve installations for leaks by turning on the 9th zone with both ball valves closed (the 9th zone valve opened with water reaching both ball valves and stopping). No leaks...hooray! I turned the system off. Now time to open the ball valve to my drip irrigation system and turn the 9th zone on again. Uh oh. The 9th zone valve will not open. Zones 1 through 8 will not open either. Nothing, no pressure, no water, no leaks. I think I did some damage by operating the 9th zone valve with both ball valves closed. Again, the system was working fine until I added the ball valves and tested. Could I have damaged my main valve? I do have a main backflow preventer as well. Not sure if I have a pressure reducing valve or not. Could either of these have blown out or gotten stuck? thanks in advance!