You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 830 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The first post

Monday, September 10th 2012, 7:45pm

by howserss

Drip zone 1 GPH high pressure

I have a drip zone in the front of my house and It has a dedicated zone (valve) that has a 100 foot hose rated at 1 GPH. My pump is doing 15 GPM at 50 PSI. What I did was hook the drip zone to run from the MV circuit. This way any zone I water also runs the drip in the front. So far so good and I do not notice any differnce on any of the zones even my heaviest that uses 5 42SA 3.0 rotors. I have a pressure switch, Pump Start Relay also and everything is playing nice together so far.
My installer really wanted me to by pass the pressure switch but I really did not want to becasue I was afraid of burning up the pump if a valve failed to open or something.
Does anyone see anything wrong with this setup?
This is all made up of a 1 inch RainBird DV valve 7VA holding, Hunter PSR-52, 7VA holding. 7VA is about .3 amps. My transformer is 1AMP.
So I would always be at .3A Drip, .3A PSR, .3A for the other zone. Thats pretty close but the controller says it is rated for a master valve and 2 zone valves. Hopefully it is compatible the other way 2 masters and a single zone at once. I already ran it for 2 hours like this and it seemed to have no probem.