You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3920 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Saturday, September 29th 2007, 2:34pm

by jksdoc

Thanks so much that did help.I just posted a new question, would greatly appreciate your input!
Thanks again

Saturday, September 29th 2007, 9:04am

by Admin

Yes, you can have any mix of rotors (any brand or any model rotor) on the same zone together as long as you match the precipation rates. Anotherwords, you just need to use a nozzle in the PGP-ATR rotor that matches the water output of the Maxi-Paw rotor. If the Maxi-Paw rotor is applying 3 gpm (very common) then use a nozzle for the PGP-ATR that outputs 3 gpm. The PGP-ATR rotors come with a complete set of nozzles (if you purchase them from so you can use the one you need to match the Maxi-Paw water output.

The PGP-ATR was designed and built to replace the Maix-Paw rotor. In fact that is the only thing it can be used for. The PGP-ATR is a PGP Rotor that has the threads on the bottom of it to allow it to be screwed into a Maxi-Paw canister base after you remove the MAx-Paw rotor guts from the canister or body in the ground.

To help you figure out how much water your Maxi-Paw or PGP-ATR rotors are outputting here are nozzle charts below:

<b>Maxi-Paw Nozzle Chart & Performance Data:</b>

<b>Maxi-Paw Rotor Instruction Manual:</b>

<b>PGP-ATR Nozzle Chart & Performance Data:</b>

<b>PGP-ATR Rotor Instruction Manual:</b>

<b>PGP-ATR Rotor Product Manual:</b>

I hope this helps.

Friday, September 28th 2007, 8:35am

by jksdoc

maxipaw and pgp-atr

Will somebody please tell me can I put a maxipaw and pgp-atr or any rotor on the same zone together? I notice the precip. rate favors the rotors over an hour period, but what about 15 min. Does the rotor travel back and forth 180 degree enough in 15 min. verses the maxi?