You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 846 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Friday, August 3rd 2012, 5:53am

by Wet_Boots

If no valve wires are connected to a controller, and the controller displays a short-circuit message, you have to suspect the controller is faulty. Just the same, unplug it, and remove the backup battery, and let it be for a few hours. Then try to get it going again.

Wednesday, August 1st 2012, 6:08pm

by jmorrise2

irritrol r series 12 station controller

the above controller irritrol r series 12 station.



says all 8 stations are shorted even after i detach all wires



how i check for short in circuits with ohmeter?



is the controller probably bad?



also all the sprinkler solenoids have a 4 inch plastic nipple looking device wires in series to each one



what are these?



thanks