You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 637 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 6 posts

Thursday, July 19th 2012, 11:31am

by GatorGuy

might be a real slow closing valve.
Worn diaphragm, debris, etc.
I'd open and clean/fix valve first.

Thursday, July 19th 2012, 10:37am

by jkabrown

Sorry. Should have mentioned that the excess water is a relatively new occurrence and the sheer amount of water is the concern, particularly after seeing this month's water bill.

Thursday, July 19th 2012, 9:45am

by Wet_Boots

nothing will prevent water draining from a low head in a zone, unless that low head has a built-in check valve - that's your Maxipaw SAM head (SAM = Stop-A-Matic)

Thursday, July 19th 2012, 8:59am

by jkabrown

Wet_Boots, thanks for the reply. I guess my biggest concern is the sheer amount of water that fills the hole and runs down the gutter. The water does shut off eventually so we can eliminate the valve. It is the sprinkler that is furthest from the valve. Is there a way to check the integrity of the pipes that the sprinkler attaches to? There is a "T" that allows a swing arm and a drain (All the heads have a drain either attached or built into the line near the head) at this point. Maybe the glue or connecting points have failed?

Thursday, July 19th 2012, 8:34am

by Wet_Boots

If the water finally stops seeping, then no worries. If it never stops seeping, you have a valve problem. If the valve is okay, but the water is causing problems, then get a SAM version of the head to replace the original

Thursday, July 19th 2012, 8:16am

by jkabrown

Not sure where leak is located

Still trying to get the hang of a new house's irrigation system. Zone 3 (of 4) has one sprinkler, a Rainbird Maxi-paw, that seeps water for a long time after the zone shuts off. Its to the point where if I take the sprinkler off of the pipe, there is a steady flow still coming out of the pipe itself that fills the hole I dug to look at the sprinkler in question and runs down the street. I have not noticed any of the other sprinklers acting this way in the zone. Not sure if a broken pipe, leaking valve or ?