You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2349 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 8 posts

Tuesday, July 10th 2012, 11:47am

by Trucker90804

I think I'd go with bubble gum first.

I thought about that :thumbsup:

Tuesday, July 10th 2012, 11:45am

by Trucker90804

Thanks for the prompt responses everyone. I was hoping for a quick fix, but did as yall suggested and cut out the pipe, unscrewed the valve and started over. The nice thing about doing that is I was able to add some Teflon to the backside, and get a few more turns out of the valve to prevent any future leakage there as well. Dope is drying on the other fittings, and we should be good to go.

Thanks again

Tuesday, July 10th 2012, 11:08am

by mrfixit

Just cut the pipe and unscrew the valve. Use teflon tape to seal the leak. Make sure you use enough.
Do NOT use pipe dope. It can clog up your valve.

Tuesday, July 10th 2012, 9:17am

by GatorGuy

That's weird stuff.
Never bought any on the "if it's too good to be true.." idea.
I have this visual of spraying it on a leaking pipe, turning on water and watching this huge bubble form.
I think I'd go with bubble gum first.

Tuesday, July 10th 2012, 9:09am

by Wet_Boots

that's a whole lot better than the Leak-Ender 2000 image I was tempted to post :D

Tuesday, July 10th 2012, 8:13am

by GatorGuy

First, boots is usually right.

On the off chance...
There is one product that may/may not help.
It is designed to fix pinhole leaks in slip connections, not threaded.
If you try it and it doesn't work you will end up buying a new valve.
It's calledleak stopper.

Now that I've given you that idea, I'll tell you that if it was mine I'd cut the valves out and rebuild.
Harder to do but far better in the long run.

Tuesday, July 10th 2012, 5:01am

by Wet_Boots

Nope. No such animal.

Monday, July 9th 2012, 11:19pm

by Trucker90804

Leak at heads for valve inlet

I just finished my first solo system installation, and went to charge the lines today and check for leaks. Eveything looks good except the male inlet threads leading into the valves. Both of them have a tiny drip. Of course eveything leading to those male couplers is glued. Can I apply any sort of sealant to the threads and not have to cut out/replace the inlets?