You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2176 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Wednesday, July 4th 2012, 6:09pm

by Wet_Boots

If you turn a bleed screw counter-clockwise, you are supposed to have water escaping. As for not responding to a controller, you have to verify that the wiring is without faults. Use your multimeter to check the resistance of each zone.

Wednesday, July 4th 2012, 5:45pm

by PersO (Guest)

Valves will not open electronically

I have three rainjet classic control valves that will not operate electronically. The valves were installed 3 years ago, however, I just began to use the valves recently. I can manually operated the valves, however, when I turn the bleed screws or unscrew the solenoids, the valves begin to leak. I have not attempted to replace any components of the valves. I checked to see if the valves were correctly installed and double checked the wiring connection at the timer. Please help.....