You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 785 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Tuesday, July 3rd 2012, 8:00am

by GatorGuy

any chance it's an extra wire?

Monday, July 2nd 2012, 10:35pm

by mrfixit

Could be a bad solenoid or crossed wiring.
Figure out which valve it's supposed to run, disconnect one wire from the solenoid. Does it still blank out? If not replace the solenoid.

Monday, July 2nd 2012, 7:11pm

by Lainiest

Rainbird SST controller- display goes blank for one zone only

I have a Rainbird SST controller that is new. I had wires coming in from the wall with no controller and took a chance and wired it up.
One wire - no matter what zone on the controller that I hook it to will not power on a zone of sprinklers. When operating manually or automatically with the controller. When that zone is selected- the proper info shows in the display and then the display will go blank. After a couple of seconds the info will display again, and then the display will go blank again.
Any ideas?
Thank you!