You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 755 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Thursday, July 5th 2012, 8:07am

by GatorGuy

When on auto check voltage at zone terminals. Should be 24v. If not, controller problem.
Not sure how as they work on manual but it's something you should check.

Tuesday, July 3rd 2012, 5:15pm

by Bill_147

Regrettably it didn't work. Same as before. I set the module on "auto" and it kicks the pump on but zone 1 (among others) just seep. Again, many of the zones work - it's just the other 4-5 that don't. Could the module not be sending a strong enough signal to the valves (silenoids?). Obviously...I'm a novice at this but paid a lot of money to have a new yard installed so definitely need the water. As previously mentioned if I turn the module to the different zones 1-11 they work just fine. Ideas?

Sunday, July 1st 2012, 11:30am

by Bill_147

Thank you very much for the suggestion. I just did it and will see what happens. The pump kicked on during the reset process - guess that would be normal...

Sunday, July 1st 2012, 11:12am

by mrfixit

Try resetting the controller as per the instructions in the manual.
Manual

Sunday, July 1st 2012, 10:44am

by Bill_147

Water Seeping Through the Sprinkler Heads

I have a Rainbird ESP modular sprinkler system containing 11 zones. When set to "auto" the sprinkler heads in zone 1 just seep water. Zone 2 works fine...but I have 5 other zones where the water just seeps out of the sprinkler heads. Oddly enough, if I manually select zone 1 and press the start the sprinkler heads pop up fine. Now, I'm forced to manually turn the dial to each zone to get the system to work. For example, I just went and turned the dial to zone 1, and pushed start and works like a champ. I will have to do this for the next 10 zones to water my HUGH lawn. Appreciate any help!