You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 790 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Sunday, July 1st 2012, 7:02pm

by mrfixit

Yes, use the white wire from each of the bundles and connect them to the controller. I usually tie all three wires together along with a fourth short piece of wire. Then I connect the short piece of wire to the common post. You don't have to jam a bunch of wires into one slot that way.

Sunday, July 1st 2012, 2:29pm

by sama123

I am intrigued by the 3 separate bundles of 7 wires idea. A follow-up to that idea would be how to connect the common wire? That is would the controller require 3 separate connections of common wire? I plan to use the Hunter Pro-C (15 zones) controller

Sunday, July 1st 2012, 12:31pm

by mrfixit

If you haven't run the wire yet you might want to consider running three seperate bundles of 7 wires each.

That way you'll have a spare wire in each box just in case.

Don't get me wrong. There's nothing wrong with how you're doing it.

Don't worry too much about the exposed wires if they're down in a box. Tape them up if you want.

Saturday, June 30th 2012, 11:23pm

by sama123

How best to wire valves in multiple valve boxes

Sorry, if this sounds like a dumb question, but it is my first installation DIY sprinkler systems. I have a 15 zone, 3 valve boxes/stations (in different locations), 5 zone per box that I need to run a wire to the controller/timer.

1. I understand that the common wire will be connected in each valve box connecting all the valves using a water-proof silicon connectors.
2. Each zone/valve will then be wired to a non-common wire back to the controller.
3. I have an 18-16 direct buiral wire for the connections
4. After stripping the outer black jacket off to expose the multiple coloured wire strands, I cut and strip the white common-wire plus the necessary wires needed for wiring all valves within that valve box, while leaving the other wires untouched.

My questions is what is the best way to connect my system with minimum wire exposed?
What do I do with the 5 wires that terminates at, say, valve box #1? valve box #2?

Thanks for your answers.