You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2185 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Tuesday, June 26th 2012, 6:42pm

by mrfixit

I don't know about Florida palms but in California the job you've described is impossible. The roots are in a ball and you have to snip them one at a time. A shovel wont even cut them. Maybe an ax will work.
Go around the tree if possible.

Florida Palms < Click on that.

Tuesday, June 26th 2012, 12:41pm

by Wet_Boots

from the mailbag, a question about a pipe

from Land O' Lakes, Florida, gateway to the Cypress Creek Flood Detention Area, reardonmiker61 writes: "I have Sprinkler pvc pipe under a Palm tree that apparently cracked . This pipe is literally in the middle of the roots under ground. The questions is if I start cutting away at the roots will the palm tree die??"

To which I can reply: "What in the heck am I supposed to know about palm trees?"

Seriously, though, since palm trees grow near the ocean, they aren't going to have taproots because those would be deep enough to hit salty water, so figure you don't want to go chopping at the palm roots to find the break. Dig a new pipe around the tree.