You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2406 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Tuesday, June 19th 2012, 12:13pm

by jimp160

I used a heat gun and the elbow came out of the poly pipe. I found a split in the elbow (not sure why after four years) and replaced it. So far, so good. Thanks for your responses.

Tuesday, June 19th 2012, 10:19am

by wsommariva

Propane torch to heat it up. Not too much or you will damage the poly

Monday, June 18th 2012, 11:41am

by GatorGuy

I just had to do this about 10 minutes ago.
I'm under ideal conditions: office, all tools, workbench, etc.
Short story: I ended up cutting the poly pipe.

I don't have a heat gun and that might have made the difference.

Monday, June 18th 2012, 10:56am

by jimp160

Main line poly pipe repair

I have a leak where my main line (black poly pipe) is attached to a one inch grey elbow (part of the manifold) in the valve box. My question is; can I get the black poly pipe off of the barb fitting of the elbow or will I have to cut the poly pipe.