You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 889 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Tuesday, June 19th 2012, 8:17am

by GatorGuy

Technically, yes.
In a class 200 pipe, if you are pushing 10 gpm (for example) through a 3/4" pipe you lose 4.3 psi of pressure per 100 feet. With a 1" pipe you lose 1.3 psi.
For a comparison chart go HERE

You are using PE. I couldn't find a chart off hand but the idea carries through.

Monday, June 18th 2012, 6:17pm

by Tubal

I'm in the same boat. I've basically got an entire 3/4" piped system (except the manifolds use 1" fittings and are 1" valves).

I'm also going to run a line about 100' and add another manifold for a garden area. Is there an advantage to using 1" for this new line when the water already runs through ~100' of 3/4" pipe before it gets to the new 1" pipe?

Tuesday, May 15th 2012, 8:34am

by wsommariva

Thank you

Tuesday, May 15th 2012, 8:31am

by GatorGuy

Sure.

Tuesday, May 15th 2012, 8:25am

by wsommariva

Adding manifold to existing manifold

Hi everyone;

Planning phase 3 of my system. I will add a manifold with 3 or 4 valves to an existing manifold with 3/4" valves. I have 35-40 working psi and 8.5 gpm. Will use MP Rotators.

Planning to install 1" valves and use 1" PE for new phase. Ok to connect these to existing 3/4" manifold?