You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 927 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Monday, May 14th 2012, 9:32pm

by mrfixit

Turn the valve on with the bleeder screw. Did that help?

Monday, May 14th 2012, 12:07pm

by MP1975

I ended up digging the first two heads and piping to check for leaks "thinking" it seemed damper then the rest of the yard. I figured that where the leak was....none was found. I disconnected the heads, cleaned them, put the heads back on and the pressure is much better. The heads raise about 3/4 of the way. So to be honest not 100% sure what the cause was but something did help.

TYVM for the response.

Saturday, May 12th 2012, 1:45pm

by MP1975

Will do TYVM.

Saturday, May 12th 2012, 11:41am

by Wet_Boots

Look for leaks - if none are evident, you need a pressure gauge to diagnose further.

Saturday, May 12th 2012, 10:55am

by MP1975

Zone 3 heads do not pop fully up.

The sprinkler heads in zone 3 do not pop fully up like my other 2 zones. "Assuming" since they are coming from the same water feed the pressure is strong enough and ensuring none of the heads are leaking etc etc kind of puzzled. I also checked the on / off manual setting on the control valve to make sure it was fully on , which it is.

Thanks again for the help.