You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2515 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Wednesday, May 30th 2007, 5:14am

by HooKooDooKu

Teflon tape.

From my limited DIY experience with plumbing, when it comes to any screw threads, teflon tape is needed. Even when I changed out shower heads in my bathroom (where the shower head had a washer to seal the connection), I still found it neccesary to use teflon tape to keep the shower head from leaking.

I assume that in your case, we're talking about a pipe that is under constant pressure (main line pipe). IMHO, it is unacceptable for a mainline pipe to have even the smallest of leaks. I also found it quite frustrating to figure out how to get a leakless threaded connection on mainline pipes.

Per instructions you will read from sights like www.irrigationtutorials.com, you should wrap the threads with about 7 turns of teflon tape, hand tighten, and then use tools to give it one more turn.

In practice, I had the most success at creating leakless threaded connections in 1" pipe was to use the 'pink' teflon tape (I believe it's marked as for use with metal pipes), use about 5 turns of the tape (it's much thicker than the white stuff), then "pre-seat" the teflon tape by rubbing it with a cloth (basically I would pretend to be screwing NOTHING on to the tapped pipe). Then hand tighten as much as possble, plus a little more with tools as needed.

But even with this method, It was pretty random on weither it would work or not. But my success when from 50/50 success/failure to 90/10.

Tuesday, May 29th 2007, 10:39am

by dpetzko

Need Help with Leaking Manifold

Purchased heavy duty manifolds from Sprinkler Warehouse (model MS-QM 1" quad manifold with M Buttress threads) and threaded caps (MS-CAP with F Buttress thread). I'm having problems stopping leaks at the MS-CAP when using the MS-CAP to cap the end of the manifold. I've tightened the caps pretty hard and am concerned about overtightening (if that's even possible).

Should I tighten the caps more, use teflon tap, get a new O-rings for the caps, glue the caps on or possibly glue a plug into the manifold?

Thanks in advance...

Dave