You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 856 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Thursday, April 19th 2012, 12:54pm

by mack

Rainbird ESP Modular Controller

GatorGuy,



Thanks for the info. I did talk to Rainbird. They suggested I talk to a local Rainbird distributor to see if they could test each board to see where the problem might be. I have not done so yet. Looks like I'll have to buy a new unit.

Thursday, April 19th 2012, 9:01am

by GatorGuy

Mack,
It does sound like your MV is shot.
Unfortunately, finding any info on troubleshooting down to the system board/component level is almost impossible. Like most electronics today they are designed to be replaced, not repaired. You might check with Rain Bird 800-724-6247.
Let us know if you find anything.

Wednesday, April 18th 2012, 8:30pm

by mack

Rainbird ESP Modular Controller

When operating in manual mode there is no voltage at the MV (main valve) terminal. As I step through the manual sequence each of six zones has 26 vac at it's terminal, but the system provides no water. I can turn on the MV manually and the system waters just fine. I looked at the terminal boards and did not see any damaged components. Could an open varistor cause this problem? Any ideas of how to pin point the problem to the computer board, the back plain board or the basic module board?