You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2597 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 6 posts

Tuesday, April 10th 2012, 8:22am

by wsommariva

It's designed to burp water occasionally.

Monday, April 9th 2012, 9:59pm

by njchoochoo1

Thanks CI. I appreciate your advice.

Monday, April 9th 2012, 7:13pm

by Central Irrigation

There are rubber seals inside of the 765 that seal when pressurized. Opening the inlet valve slowly won't allow enough pressure to build in order to seal the gaskets. If once the gaskets seal, it continues to leak from under the "bell" then the gaskets maybe cracked or weathered.

Sunday, April 8th 2012, 9:03pm

by njchoochoo1

Febco 765-1

Thanks Wet Boots. Why would water dribble out of the canopy the first time I tried, and then pour out of the vent the second time? Just trying to understand. Thanks again. :)

Sunday, April 8th 2012, 2:49pm

by Wet_Boots

The bottom arrow points at a drain opening that was used to connect air to winterize the system. You should be able to thread in a plastic plug.

Saturday, April 7th 2012, 10:57pm

by njchoochoo1

Febco 765-1

I went to start up my system today, and noticed water coming from the top of the BVP. I then went and moved the ball valves for the inlet and outlet. I realized after some more research that this was not necessary. :S Anyway, once I went to start the water through, water was pouring from the bottom (see red arrow). Did moving the ball valve to close then open get it frozen in the closed position? I'm guessing that this will require the BVP to be replaced? Any assistance would be appreciated.