You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2275 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Tuesday, March 27th 2012, 6:59am

by seanik (Guest)

Thanks guys! makes complete sense, I was only calculating flow rates and did not consider the precip rates. Best route will likely be to add another zone with the spray heads as I have room for one more in my controller without adding an expansion module.

Monday, March 26th 2012, 10:11pm

by Mitchgo

Again apples to apples and oranges to oranges. However,

while a MP has a less Precip rate than rotors. Depending on the situation a couple mp's on a rotor zone doesn't hurt

Monday, March 26th 2012, 6:21pm

by grey

General rule of thumb you don't want mix rotors and sprays on the same zone. Precipitation rates of sprays are higher than rotors. Area under rotors would be dry while under sprays would be overwatered. Consider short to medium range rotors like Hunter PGJ or Rain BIrd 3500.

Monday, March 26th 2012, 3:24pm

by seanik (Guest)

Modify existing system for new pool in yard

Need to modify my existing system to account for a new pool that is going in. Luckily the main line and lateral runs will not be impacted by the dig for the pool thanks to some pre-planning on my part with my installer last year.

Current setup has 2 zones covering the back yard with Hunter I-20 around the perimeter of the yard. Easiest route will be to replace two of the current rotators with a series of spray heads or MP rotators.

Question I have is can you have a zone with I-20's and MP's or standard spray heads?

Thanks in advance!