You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2587 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 10 posts

Sunday, March 25th 2012, 7:06am

by Wet_Boots

Pex is usable, but CPVC is stronger, and installs more neatly. I would still transition back to copper to exit the house, and to continue to the PVB

Sunday, March 25th 2012, 6:42am

by louis13

I have about 30 feet to run indoors. So I can use tan pipe? What about Pex?

Saturday, March 24th 2012, 7:46pm

by Wet_Boots

Easy - no indoor PVC in Jersey (and yes, you'll see it all over, but codes have changed) - If you had a really long run of pipe indoors, you would use the beige-colored CPVC pipe and fittings. For less than 20 feet, stay all copper. In any event, a pro doesn't run plastic pipe through the exterior wall.

Saturday, March 24th 2012, 5:51pm

by louis13

how could i find out what my codes are here in New Jersey?

Saturday, March 24th 2012, 5:46pm

by Wet_Boots

Sch 40 PVC indoors is a likely code violation, depending on your location - the rules want it used only for drainage. type L Copper is pricey, but it's strong.

Saturday, March 24th 2012, 5:07pm

by louis13

I was going to use sch 40 1" PVC instead of copper from the meter area to the that OK or do i have to run copper?

Saturday, March 24th 2012, 5:00pm

by Wet_Boots

What you should be doing is to simply make your connection, right after the water meter, and bring the copper outside to your PVB, and then do a flow and pressure test. Only at that point can you know exactly what your water supply is.

Saturday, March 24th 2012, 4:39pm

by louis13

I measured the pressure on the hose bib and I believe it was 45-50 lbs. never did a flow test

Saturday, March 24th 2012, 4:35pm

by Wet_Boots

You measured your pressure? You did a flow test? First things first.

Saturday, March 24th 2012, 4:24pm

by louis13

1" Wilkins pressure vacuum breaker...

Will I have enough pressure for the system with a 3/4 source?