You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 993 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Friday, March 9th 2012, 8:46am

by GatorGuy

Since you verified that power is going to each zone at the controller level, my guess is someone put a shovel through the wires. Some were cut, some were just nicked and are shorting. Far more likely than all the solenoids going out at the same time.
First thing I would do is locate a valve or two and see if signal gets through.
If not, time to start tracing wires.

There are a number of activators and tracers HERE that can help.

Friday, March 9th 2012, 8:01am

by Kamikaze71

Only 1 zone working

I bought a house 3 years ago and was told that the sprinkler system just stopped working the summer before. I've finally found the time and gathered up the patience to deal with it and heres what I've got....



I have a rain bird 16 zone controller with 15 zones connected.



The controller appears to be working, it's keeping time, has programs stored and when I manually activate zones, the controller is switching from zone to zone at the controller (checked wiring with a test light).



Now, weird deal is, when I start manually activating zones, zone 3 is the only zone that actually shoots out any water, but once it's active, it will not turn off. I have to turn off water supply to turn zone 3 off. Once the water stops flowing, I can turn water back on and go on to zone 4-15, but they're dead.



Surely all the solenoids didn't go bad at once?