You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 846 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 7 posts

Friday, December 30th 2011, 8:35pm

by howserss

Sorry to be such a pain I just needed to make sure. This is the first time I have worked with a pump or sprinkler system.

Well it seems like I have a good system I had the pump installed in 2008 with a 12 point well. Now I will finally get the sprinkler system installed.

Thursday, December 29th 2011, 6:12pm

by Wet_Boots

Yep, it's enough

Thursday, December 29th 2011, 5:26pm

by howserss

It has a pressure tank on top of the pump will that be enough.

Thursday, December 29th 2011, 8:57am

by Wet_Boots

You still want a pressure tank. Sprinkler valves can shut off a lot faster than you can close a faucet, and the resultant hammer could be trouble, for which the tank is a sure cure.

Wednesday, December 28th 2011, 7:52pm

by howserss

So that means just hook up the valves to the controller and the pump will turn on automagically when a valve is opened, correct?

Wednesday, December 28th 2011, 1:12pm

by Wet_Boots

a pressure switch is intended to work in conjunction with a pressure tank (and a relief valve) to make a self-contained water supply - no controller connection is involved

Tuesday, December 27th 2011, 9:12pm

by howserss

Controller hookup with pressure switch

I have a pressure switch on my pump (1.5 HP Sta Rite) and I have 230V hookup to the pump. When I turn on the water at the hand valve the pump comes on. I want to have a controller installed. WIll the controller just need to be wired to the manifold valves and not to the pump at all. If a valve is opened then the pump should come on correct?