You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2476 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Wednesday, December 14th 2011, 10:57am

by wsommariva

Good. I cut "slots" last year - more like butchering, but this time I'll make nice cuts with my oscillating tool.


Wednesday, December 14th 2011, 9:27am

by Wet_Boots

Pros cut slots, not holes. Boxes can always lift out that way.

Tuesday, December 13th 2011, 3:17pm

by wsommariva

Valve boxes

Last install I used a reciprocating saw to cut out holes for my water supply line and PE from each valve.

I see Orbit has a base with pre cut out holes. Is this the way to go or just cut up a standard box with my saw?