You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2510 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Thursday, December 8th 2011, 5:48pm

by hi.todd

Thanks for the confirmation!!

Merry Christmas!!

Tuesday, November 1st 2011, 4:22pm

by Central Irrigation

Just this spring we did some work for the city irrigating some center medians along a county road. I used the the precision nozzles on that project and was able to install 72 sprays/zone. They were all 12ft halves. Had to get a little creative with the lateral lines, but what a savings! Precip. rates are lower, but who cares?! Still haven't installed them on a residential system, though. Still don't want another nozzle box in the service van.

Tuesday, November 1st 2011, 8:05am

by hi.todd

I had 45 PSI static, did not run dynamic. It was a bid that I had given and I was pretty sure that I had 3/4 supply coming off of house plumbing. I peeled back the insulation and it was 1/2 inch. If you haven't tried them, and you get in a pinch, they will fix it. They come in male and female thread so specify female for compatibility with non Toro. Do the whole zone in them to see the real deal.
I have been off of the site for a couple days.


Sunday, October 30th 2011, 11:54am

by Wet_Boots

What pressure did you have? (static and dynamic)

Saturday, October 29th 2011, 4:11pm

by hi.todd

The Toro Precision Nozzles

If you got low pressure, low flow G.P.M. and you want to fix the poor design. This is not counting the possibility of a valve that needs to be replaced, leak in a lateral, partially open water supply.

The Toro Precision Nozzles are better than the hype. I recently had a .5" supply and had to design and install sprinklers on a budget. The nozzles were more expensive, but they saved me timer size, pipe, and wire. I am not a walking commercial for toro nozzles, but wow.

I am just saying for what it is worth. 8)