You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2468 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 7 posts

Tuesday, September 20th 2011, 8:24am

by wsommariva

I'll take mine in to be very safe.

Monday, September 19th 2011, 4:52pm

by Wet_Boots

Never is it done for a pro system - all my installs include a low-point drain in the outdoor plumbing

Monday, September 19th 2011, 10:35am

by wsommariva

How common is it to remove the PVB and take it in?

Sunday, September 18th 2011, 2:22pm

by Wet_Boots

It's mostly an installer's trick for late-season installations.

Sunday, September 18th 2011, 9:11am

by Central Irrigation

Master Valves aren't common here in Minnesota. If a system had one, that would work fine. However, almost every system has a drain in the basement or a blow-out fitting before the backflow. Turning on a zone with the water shut off, provides just enough drainage to drop the water level in the down pipe.

Saturday, September 17th 2011, 7:09pm

by Wet_Boots

Ever try closing the flow control on the master valve and opening the bleed screw?

Saturday, September 17th 2011, 6:58pm

by Central Irrigation

Cold nights are on the way!

The blow-out season is coming quickly to the folks that live here in central Minnesota. Temperatures are beginning to dip down to the freezing point over night, and many system owners are feeling the urge to have their system's winterized.

I thought I would write about some simple tricks that could prevent some possible freeze damage. The most common of which, being burst backflows. Backflow devices are the most susceptible to freeze damage since they are above ground and fully pressurized, thus are typically the first piece of the system to freeze. Most Backflow Prevention Devices can sustain freezing temperatures for a few hours, but sustained freezing temps. for more than 4 hrs. can prove to be too much for most PVB's. I usually tell homeowners that when they begin to hear it's time to cover their plants, it's time to cover their PVB, as well. Simply wrapping the PVB and pipe with an old jacket, blanket, or insulation remnants, may just give your PVB a fighting chance against some overnight JACK FROST. Draining the PVB works well also. I have instructed clients in the past to drain their PVB's when temps. continuously fall below freezing for extended days. The process is simple. Turn off the water at the master shutoff. Turn on a zone from the controller. Open the drain to drain any extra water from the PVB. Turn off controller.

Blow-out season is a very busy time for most contractors, and there are no gaurantees your contractor will be able to winterize your system at the drop of a hat. Though, these tips are not gaurantees against freeze damage, they can provide an extra day or two when the weather turns nasty.