You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2052 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Saturday, September 10th 2011, 8:39am

by Central Irrigation

Pressure test the mainline only. I hope you've installed some sort of backflow prevention decvice!? These devices have a test cock on them that allow you to insert a pressure gauge in order to test the device. These test cocks work great for pressure testing the mainline. Fill the mainline until you're confident it is fully pressurized then turn off the water to the system. If the pressure gauge drops, you have a leak in the main. If it holds steady pressure, you're in business.

Like you stated, a leak in a zone line isn't as crucial since you have drains. It still isn't preferred, however, but I wouldn't go and cap all the heads in order to be absolutely certain. If a leak of decent size is present, it will show up over time.

Install all valves before pressure testing the main.

Saturday, September 10th 2011, 7:43am

by TeaMan

System Startup Pressure Testing

I have a fairly large system I'm about in the middle of installing. It has over 2500 feet of poly pipe and about 150 heads with 12 zones. My yard is approximately 1 acre. I trenched the whole system rather than using a knife for various reasons I won't get into. Now I'm wondering when I can safely backfill....

I'm wondering how, and if anyone pressure tests their system before firing it up.

I can see pressure testing the main line up to each manifold. This is fairly easy since the main can be turned on, one valve on each manifold can be opened to allow water to reach the manifold, then closed and the connections inspected. After that it gets a little more complicated. You need water at operating pressure at each connection to test it properly, and if it's tested with heads in place one would get pretty wet. If each head is removed and capped, it would be very tedius, and some type of valve would have to be put at each location, in my case about 150 to release water until it reached that head, then pressurize to operating pressure.

Last, I have automatic drains incorporated into the design. They essentially create a leak so to speak. Not under pressure, but when the pressure is released. If they are going to slowly drain the line over time anyway, does a small drip leak in a zone really matter?

I'm looking for the smartest and best way to do this if it's even done at all.