You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2484 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Thursday, September 1st 2011, 6:20pm

by Wet_Boots

There is also a finite amount of power a controller can put out, but it's the water supply more than anything that makes the "one zone at a time" rule

Thursday, September 1st 2011, 11:13am

by mdbarn2003 (Guest)

Controllers only allowing 1 zone to water at a time?

Is it normal for contollers to only allow 1 zone to be watered at a time? I am new to the irrigation world, and I understand there is a finite amount of water and pressure at any given point, but I assumed that I could get more than 1 zone watered at a time.