You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1221 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 6 posts

Tuesday, August 16th 2011, 8:16am

by Wet_Boots

Besides the metal bypass strip that is factory installed, to be removed when a sensor is connected, there is a switch on the front panel to bypass the sensor.

Tuesday, August 16th 2011, 7:55am

by Linda s (Guest)

Thanks I have another question which may be my problem. On the mini-clic there are two lights. The top light says "sensor bypass" and states "red light indicates sensor is bypassed". So that light should be off and not red, correct? The light below it shows either red when "wet" or green when "dry". I think I had the top light on too - showing red. Would that be my problem causing the sprinklers to water when it is raining?

Monday, August 15th 2011, 4:17pm

by Wet_Boots

Yep. Pretty visible, though. Could just be the receiver unit is bad.

Monday, August 15th 2011, 3:23pm

by Linda s (Guest)

How do I find that out? I can see that they screwed in two yellow wires to the two sensor places Is it behind that?

Monday, August 15th 2011, 11:23am

by Wet_Boots

Is the metal bypass piece still in place on the terminal strip?

Monday, August 15th 2011, 9:54am

by Linda s (Guest)

Hunter Pro c rain sensor problem

I just had my Hunter Pro C replaced and now the rain sensor is not working properly. The switch is in the correct place and the sensor red light is on and the other light displays red when it is "wet" and green when it is "dry". However, the sprinklers still come on at the designated time when it is raining and it does not read "sensor off" and stop the sprinklers like it should. As I mentioned the switch is on "active" like it should be. What could be causing this problem and how do I fix it?