You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 995 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 8 posts

Thursday, July 28th 2011, 5:23pm

by Wet_Boots

If a disconnected zone never comes on, no matter what zone you operate, then you suspect the controller, if those same zones were randomly operating before, when they were still connected to the controller.

Again, try to program a time delay between zones.

Thursday, July 28th 2011, 4:12pm

by tt8377

Boots

I disconnected zone 3 and 4 one at a time and they both did not come on when engaged.

TT

Friday, July 22nd 2011, 6:27pm

by Wet_Boots

Go back to the controller and make a diagram of what wire is attached to what terminal. then detach one of the zone wires, and see if that zone still comes on.

Friday, July 22nd 2011, 2:21pm

by tt8377

mitch,
unfortunately, i think you are right. im not much of an electrician. i looked in the box in the yard and the wires are pretty neatly attached. and the box is very neat. but after checking solenoids, cleaning valves and diaphrams, its still same result. i can get the individual zones to work properly when i twist the solenoids by hand. but not via the computer. thanks for everyones help. i will try and troubleshoot wiring issues.

tt

Friday, July 22nd 2011, 1:27pm

by Mitchgo

Sounds like a wiring issue.

The wires of these zones are tied together either at the controller or on the field- allowing them all to turn on at once

Friday, July 22nd 2011, 1:00pm

by tt8377

K, tested solenoid (it worked). i flushed out valve ( nothing looked to be obstructing ). i reset computer and tried to run zone #3 and zone #4&5 came on as well. i only tested zone #3 s solenoid and flushed#3 valve diaphram. I thought that if there was any problem it would solve it @ zone #3. Because when i run zone #4 solo, zone #3 still comes on. This is confusing. sorry

tt

Thursday, July 21st 2011, 2:20pm

by Wet_Boots

See if you can't program a delay between zones.

Thursday, July 21st 2011, 11:04am

by tt8377

multiple zones operating at same time

Hi,
I have a hunter system. when using electric controls multiple zones come on when 1 zone is chosen. i tried each zone manually by hand to turn on and off and the correct zones came on without additional zones. Any thoughts are appreciated. Thanks

TT