You are not logged in.

  • Login
  • Register

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 668 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Tuesday, July 26th 2011, 2:08pm

by Matt Dildy

to add to what mitchgo said i would program a "mock" start time to double check controller function before walking away and assuming all is well

example:

set program A start time #2 for a start just a few minutes from whatever time the controller has (so if its 12:45pm set a start at 1:00pm). make sure whatever day it is you have turned that day on. now sit back and wait, at 1:00pm zone #1 should kick on. turn controller off before it cycles all the way though, we just wanted to see it start. dont forget to erase that "mock" start time.



99% percent of the time these programmed "non-starts" are a programing error of one sort or another, typically if a controller will manual correctly it will run in automatic correctly, with a few exceptions.

Friday, July 22nd 2011, 12:54pm

by Mitchgo

Read them again?

Stick with 1 program ( A) , 1 start time, Days you want to water, and zone run times on all the zones you have

Friday, July 22nd 2011, 11:50am

by Lolly

Hunter System will work on manual but not on program

What am I doing wrong read manual and followed all steps