You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2833 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Sunday, July 24th 2011, 9:23am

by AutomaticSprinklers

We used to always hook in on the side on Maxi Paws along driveways and roads. They were more resistant to breaking swing els when driven over by cars. If you can replace the guts go that route. I am assuming that your connection is on a green or black riser pipe. I would recommend switching to a swing pipe connection. It recommends not using a torch to make connections but it makes it a lot easier to put the barbs in the pipe and we never had trouble with it as long as you don't heat it too long.

Saturday, July 23rd 2011, 2:53pm

by Mitchgo

If you have the same sprinkler head to replace it you can just 'gut swap ' it. Unscrew the top collar and replace it.

You probably have a 6" or 12" pop up - a side port connection is pretty common because it's easier to install the connection

Saturday, July 23rd 2011, 2:39pm

by Wet_Boots

Just dig some more, and you may find where to make pipe connections without having to dig up any shrubs.

Side entry heads were commonplace, and are easily repaired when you have the parts and the tools.

Saturday, July 23rd 2011, 1:37pm

by CharlyTexas

Help! Sprinkler Replacement Snafu

I bought a home with a Richdell irrigation system which needed sprinklers replaced, e.g sprinklers not popping up unless I pry them with a screw driver etc. I decided after getting a few quotes from irrigation companies to replace the sprinklers myself. A couple of youtube videos and and I was good to go! Other the the manual labor to dig up the sprinklers , overall the process was relatively simple. Unscrew, blow out dirt and debri and screw in and adjust nozzle, as a female I was damn proud of project until I ran into a sprinkler that does NOT screw in the top of the pipe but screws in on the side. The hole I would need to dig in order for the sprinkler to have enough space to rotate to remove would be huge not to mention I would have to remove a few plants in the bed. My question is two fold, 1). why did they do that??!! 2). can I cut the 4" sprinkler down to give more clearance in the hole in order to unscrew it from the pipe?

I really hope this makes sense!