You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2680 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Sunday, July 17th 2011, 12:16pm

by Mitchgo

A lot of times there is a 3/4" x 1/2" Thread x Thread Bushing that is also installed. Check your old head and look for a white fitting at the bottom of your head- unscrew it and install it on your new head

There's also a stupid swivel fitting out there that allows the head to just keep spinning, but you would have to hold onto it to take the head off so I doubt this is it.

Sunday, July 17th 2011, 11:19am

by servicetechMA

if you tried to do a quick change,meaning you just dug around the top of the head and unscrewed it,there is probably dirt around the elbow at the bottom. If you dig up the whole head all the way down to the elbow,if you dig a little below the elbow,you may be able to turn the elbow upside down so the hole and the threads face down,and the residual water will flush the dirt out of elbow. Or just dig it out the same way,turn the water on for a second to flush it all out. If the old head screwed off NO PROBLEM the new one will screw on no problem,unless of course there is dirt.
Another possibility, all i do is quick changes,but you cant use a hunter pgp to change out a rain bird 5000 that is in the ground. Reason being there is an extension on the bottom of the Rain Bird head,and the bottom of a pgp is flat, so the elbow is below the actual bottom of the head,and is surrounded by dirt. maybe check that out.
Other than that,just dig it up completely,turn water on to flush elbow and clean threads off,re-install new head.done deal. worst case scenario you need a new elbow that you can get at lowes or home depot.

Sunday, July 17th 2011, 10:42am

by Nick1234 (Guest)

Sprinkler head replacement

I removed my old sprinkler head and tried to replace with a new one, same model, but it won't screw on just spins in a circle???? Any info on how to fix, or what is going on??