Reply
Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.
Attention: The last reply to this post was 2111 days ago. The thread may already be out of date. Please consider creating a new thread.
The last 6 posts
Hi,
As you have mentioned that you have a leak in the valve of your sprinkler system. and you can hear the sound of leaking but you are unable to recognize the leakage that from where water is coming. According to me you have to change the valve by yourself or by hiring a plumber. These type of leakages can be then controlled by latest technologies and instruments which are generally used by leak detection companies.
RE: Leak Detection
I am working on a sprinkler system that apparently has a leak. I say apparently because I have a zone with only 2 heads, 1 Maxi-Paw and 1 spray head. First I noticed that the pressure on both heads was low. But when they are activated the water meter seems to go full blast. Shut them down, water meter is quiet. I then capped off both heads so no water would flow. Fired up the valve, of course nothing through the capped off heads, but the water meter is going full blast. I can hear water flowing through the valve, but it is showing up no where. Any suggestions?
Did you find the problem in the end?
Sometimes the grass will bulge up instead of water coming out.
Agree with boots... Let it run for 10-15 min and try and find a wet area.
If you can't find anything your next step aside from running new pipe from the valve to the sprinkler heads is to isolate the line out.. Try to find the 1/2 way mark of the piping between the valve and sprinkler heads, dig up and cut / cap . Then check your meter again.. and so on.. Sometimes it's better to replace a section of piping rather then finding the leak.
Keep walking the area, and maybe have a helper, because if it is a large flow of water, there may be a deep cavity it is flowing into.
Leak Detection
I am working on a sprinkler system that apparently has a leak. I say apparently because I have a zone with only 2 heads, 1 Maxi-Paw and 1 spray head. First I noticed that the pressure on both heads was low. But when they are activated the water meter seems to go full blast. Shut them down, water meter is quiet. I then capped off both heads so no water would flow. Fired up the valve, of course nothing through the capped off heads, but the water meter is going full blast. I can hear water flowing through the valve, but it is showing up no where. Any suggestions?