You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1250 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Friday, June 24th 2011, 6:12pm

by Wet_Boots

buy a new head

Friday, June 24th 2011, 4:32pm

by brucecarson

RADIUS ADJUSTMENT SCREW PGP

I just turned the radius adjustment screw on my PGP rotor too far. Water is pouring out. How do I replace it?

... I'm writing this later. Luckily I found the little screw lying beside the rotor. I had some extra nozzles. I replaced the nozzle that had blown out and then forced the screw through the tiny hole in the top. All is well again!