You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1221 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Tuesday, June 21st 2011, 8:32am

by Wet_Boots

Of course there is continuity between the various output terminals of a controller, at least those connected to valves. The resistance readings would show two solenoids in series. Output to solenoid to common to solenoid to output.

Monday, June 20th 2011, 9:35pm

by cmarcus (Guest)

Help with odd wiring issue

Hello Everyone,



Great forum! I've got a bit of an odd one here.



I was running my sprinklers and everything was working fine, then suddenly poof the water shut off and the heads retracted. I went to the timer and it was still calling for water. I checked the voltage on to the zone that's currently on and got a 26VAC. Tried having the timer fire other zones, no sucess.



Here's where it gets a bit odd for me. I check the other zones that are not currently being called, and I'm seeing 26VAC to each of them as well. I pull the power to the timer and begin continuity checks, no shorts from common to any zone. I pull the wires to all four zones from the timer and check them against each other for continuity. I was a bit supprised to find contunity (~56 ohms) between each of the four zones.



Before I begin digging up the back yard, I wanted to see if anyone could explain if I've misunderstood or overlooked something in my troubleshooting.



Note: around 2 years ago I did rewire the valves for a similar problem, and it ended up being a broken common wire. However this time is different because I'm not sure how I could be seeing continuity between each of the four wires that go to four different solenoids.



Any help would be appreciated! Feel free to e-mail.

-Chris (cmarcus1979@charter.net)