You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2555 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 9 posts

Wednesday, June 22nd 2011, 12:59am

by grey

Not really. I read their reviews seems a little finicky. I think I will be going with Hunter PGJ or Rainbird 3500.

Tuesday, June 21st 2011, 11:31pm

by Mitchgo

the pgp and 5000 are essential the same, though the 5000 has the ability to control flow and actually turn off the rotor. The pgp doesn't ( though the hunter i20 does)

It's true wind will push the water. It's recommended to water early morning where in most places in the world- the wind is the least in the morning. However, if designed properly wind shouldn't be a huge deal . Or design it to compensate for a constant wind application.

2gpm a nozzle is fine. I generally don't go lower then 2

Have you consideredMPR Rotator nozzles?

Tuesday, June 21st 2011, 11:06pm

by grey

Thanks for reply Mitchgo. I didn't check 5004 yet but aren't they the same range as PGPs? As far as using smaller nozzles I read recommendations not to use less than 2 GPM nozzles since little wind blow away water. Then again I'm no professional just reading and open to suggestions.

Tuesday, June 21st 2011, 10:02pm

by Mitchgo

Reading your other posts and that you are starting up your own system.

My personal recommendation of rotors are the Rain Bird 5004 +

In my opinion these heads are far superior then pgp's. With using your difuser, flow control ( at the head) and low angle's ( if need be) you can get this head to water almost any area

Tuesday, June 21st 2011, 9:55pm

by Mitchgo

Smaller nozzle gpm just means longer run time... It's actually a good thing to have

Tuesday, June 21st 2011, 9:54pm

by Mitchgo

Based on the charts If your zone is designed properly- They will throw about 30'

Tuesday, June 21st 2011, 12:37pm

by grey

dynamic, after all pressure loss calculations.

Tuesday, June 21st 2011, 7:48am

by Mitchgo

is your pressure 30-35 static or dynamic?

Tuesday, June 21st 2011, 12:06am

by grey

Hunter PGP too long for 25'?

Based on the charts PGP is not optimal for these distances. If I use the smallest nozzle the GPM would be too low. Is that correct? My pressure is about 30-35 PSI.