You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1167 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Saturday, May 21st 2011, 7:03pm

by criceX (Guest)

Makes sense! Thanks for clarifying that. My old house only had 4 stations so they just happened to coincide.

Friday, May 20th 2011, 10:46pm

by mrfixit

You only need to program ONE start time then the valves run in sequence there after. The way you have it set up all 6 valves will run 4 times. 123456-123456-123456-123456. There' aren't 6 start times available. Only 4.

Friday, May 20th 2011, 9:34pm

by criceX (Guest)

Pro-C stations available on manual and time setting but not on program start time settings

Hello all, glad I found this board!

I have a Hunter Pro-C controller, 2nd one I've had in 2 houses... Last house, had zero problems with it and enjoyed the simplicity of it.

New house, new controller. I have 6 stations spanning 2 modules. Stations 4-6 are on Module #2. When I go and manually run the stations I get access for ALL 1-6 stations. When I set station run times for programs, I also get access for all stations. HOWEVER, when I go set program start time, I only get stations 1-4. I've tried resetting it through the interface, pulling the battery, unplugging it, removing and reseatting the modules... can't figure out what it could be. All the stations work perfectly fine when running in manual mode as they should for as long as they should. ?(