You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2599 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Monday, May 9th 2011, 12:20pm

by mrfixit

I've found that it's either a broken pressure regulator or a valve isn't turned on all the way when I run across your situation. Sometimes a plumber wont turn the water back on correctly at the water meter.

One time on a 2 inch line they had 2 bad ball valves, one on either side of the backflow preventer. Both balls were broken inside. The valve handles looked open but inside they were barely open reducing the pressure to the whole sprinkler system.

Monday, May 9th 2011, 8:05am

by wiesph

Low Pressure.. ideas.. HELP

I have a system which is 10 years old which just stopped working correctly. What is happening is that I am getting low pressure across all 6 zones which is causing some of the heads in some of the zones to not pop up and spray correctly and some to pop up but not spray under full pressure. System has hunter valves and heads on it. I have done the following. I have confirmed that there is no leak when the system is off. Meter does not spin. I have manually actuated each zone valve manually and still get the same symptoms . I have confirmed when one zone is on that there is no leaking on other zones. I have had a backflow specialist come check the valve and confirmed 70 psi on front side of valve and 67 psi on back side of valve. I have been told that pressure is normal. I had Seminole county come out and check and they say that pressure is correct to the water meter. I have dug up the water line almost to the water meter and the line looks normal ( the line splits after the water meter and runs to irrigation line. The other line runs directly to the house. Does anybody have any idea's of what else to look for. This is extremely frustrating. HELP