You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1322 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 7 posts

Sunday, May 8th 2011, 5:44pm

by CAWahine (Guest)

Wires Between Valves Cut

Thank you again for your help. A neighbor who is more familiar than I was able to help me fix everything and they are working.

Sunday, May 8th 2011, 3:41pm

by Wet_Boots

Are you saying that these cut wires are in a valve box? (which begs the question of what was going on)

-

Dry-conn wire nuts just buried in the ground? Abso-freakin-lutely not! You make this splice as though there was 500 volts in the line, and you are going to walk barefoot over the repair.

Sunday, May 8th 2011, 11:38am

by CAWahine (Guest)

Wires Between Valves Cut

Thank you so much for taking time to respond.
The wires are cut near the solenoids and the valves are atleast 12" tall each from the ground. After reading on here some more, can I splice and use a dryconn connector near the solenoids and not bury as you describe?

Sunday, May 8th 2011, 11:13am

by Wet_Boots

What makes this exacting is that the usual result of such a repair is a buried splice that no one will know the location of, and should it ever become faulty, it will be very difficult to diagnose and repair. If you have enough slack, you can reconnect the individual wires with the appropriately-sized wire nuts (smaller, rather than larger) and to "pot" the group of splices in silicone caulk. Potted wire splices have a pretty good track record in the field. For future serviceability, I would place a small valve box over the splice location, so there is no question where it is.

-

If you have any doubts about doing any of this, better to run a new cable in place of the old, and have no splices in the field.

Sunday, May 8th 2011, 9:19am

by CAWahine (Guest)

Wires Between Valves Cut

Yes, there is slack. He cut 5 of the 6 valves for the back yard, both the ground and the valve wire. The house is only 9 months old so everything is very new.
Thank you!

Sunday, May 8th 2011, 7:57am

by Wet_Boots

The repair is a very exacting task. Less than perfect will not do. Is there any slack in the cut cable?

Saturday, May 7th 2011, 7:34pm

by CAWahine (Guest)

Wires Between Valves Cut

Our son cut the wires between the sprinkler valves in the backyard. :wacko: How do I repair? Do I just try to reconnect them at the cut? Never done anything like this but with some help I think I can do it. Thank you!