You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1296 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Thursday, May 5th 2011, 12:18pm

by wide (Guest)

I have the same issue. I am certain it is not a valve or solenoid problem. My question is; could it have something to do with the Pressure Vacuum Breaker? The PVB makes a rapid, steady clicking noise when the valve should be closed.

Friday, April 29th 2011, 6:31pm

by hi.todd

Ouch!

Friday, April 29th 2011, 7:58am

by Wet_Boots

"Ohhhh, snap!"

Friday, April 29th 2011, 1:26am

by mrfixit

Maybe you changed the wrong valve.

Thursday, April 28th 2011, 10:55pm

by pop51575

Valve won't close..... replaced valve twice....did a clean install (no leaks)..no debris in the solenoid or bleeder valve.... zone still on.

I'm blown away that i can't find a solution on my own. Thanks anyone who helps. I've determined its not wiring or the controller box. We directly hard wired it.... and on a zone that is working properly. I have tried 2 new valves and 4 different solenoids (all new)....... THE ZONE STILL STAYS ON! I even brought over a neighbor that has repaired tons of them and can't figure it out. I can't see how the plunger would be stuck on after 2 replacements and multiple solenoids. Any suggestions? We also ran w/out any power at all....still won't shut off. I'm perplexed to say the least, any help would be appreciated. All over zones work properly.